Access Gateway Appliance

For each Access Gateway Appliance imported into Administration Console, edit the settings.properties file on Access Gateway if the primary Administration Console was not configured as the Audit Server. The settings.properties file is required for JCC Communication between devices and Administration Console.

If the primary Administration Console was configured as an Audit Server, you must update the IP address of the new primary Administration Console in the Auditing page.

When the Primary Administration Console Was Not Configured as the Audit Server

  1. At Access Gateway Appliance, log in as the root user.

  2. Open a terminal window and shut down all services by entering the following command:

    /etc/init.d/novell-appliance stop

  3. Edit the settings.properties file:

    1. Enter: vi /opt/novell/devman/jcc/conf/runtime/settings.properties

    2. Change the IP address in the remotemgmtip list from the IP address of the failed Administration Console to the address of the new primary Administration Console.

    3. Enter :wq! to save and exit.

  4. At Access Gateway Appliance, start all services by entering the following commands:

    /etc/init.d/novell-appliance start

  5. (Conditional) Repeat this process for each Access Gateway that has been imported into Administration Console.

When the Primary Administration Console Was Configured as the Audit Server

  1. On the secondary Administration Console Dashboard, click Auditing.

  2. In Server Listening Address, change the IP address to the secondary Administration Console’s IP address.

  3. Click Apply > OK.

  4. (Conditional) Repeat this procedure for each Access Gateway that has been imported into Administration Console.