Send Data to an AS/400

To send data to an AS/400

1. Open the File Transfer dialog box.

   1. Start Reflection and log on to the host computer as usual.

   2. The steps depend on your user interface mode.

      User Interface Mode	Steps
      The Reflection Ribbon	On the Session tab, from the Transfer group, click File Transfer.
      The Reflection Browser	On the Reflection menu, choose Tools and then File Transfer.
      TouchUx	Tap the Wrench icon and then under Tools, select File Transfer.

2. Click the Settings button, and configure the file transfer settings.

3. From the AS/400, Options, and Translation tabs, specify the way you want Reflection to handle AS/400 transfers.

4. Click OK.

5. From the Transfer dialog box, under Local, do one of the following:

   • Browse under Local folders, and then select one or more files from the list.

     -or-

   • Type the path and filename into the File names box.

6. Under Host specify which host file should receive the data using one of the following techniques:

   • Click Show Host Files and browse to select a host file.

     -or-

   • Type the file information using this syntax: LIBRARY/FILE(MEMBER).

     NOTE:If Reflection is configured to use a character set that is not supported by your host, you cannot display host files using the Show host files button.

7. To initiate a file transfer, do one of the following:

   • Click a Transfer button to move the file in the indicated direction.

     -or-

   • Drag the source file, and then drop it on the desired destination file.