Manually Enable Serial Device-to-host Communications

Although most hosts automatically initiate serial device-to-host communications (via the Csi?9i control function), if you are using a host application that does not, you may also need to manually enable serial device-to-host communications.

To enable serial device-to-host communications manually

Open a VT terminal session.

Open the Document Settings dialog box.

The steps depend on your user interface mode.

User Interface Mode	Steps
Ribbon or Reflection Browser	With a session open in Reflection, from the Quick Access Toolbar, click .
TouchUx	Tap the Gear icon and then select Document Settings.

Under Terminal Configuration, click Select Terminal Type.
Under Terminal Settings, click Terminal Setup.
Click the Advanced button.
Select the Serial device to host check box.

The Configure button from the Terminal Setup Advanced Options dialog box is equivalent to the Configure button from the Logging Settings dialog box. You can use the button from either dialog box to configure your serial device port.
Click OK.