Configuring SmartConnector as a Transformation Hub Producer
The configuration steps provided in this section are applicable only for SmartConnector version 25.1 or earlier.
For SmartConnector version 25.4 or later, follow the configuration steps provided in the Configure SmartConnector as a Transformation Hub Producer section in the SmartConnector documentation.
For SmartConnector version 25.4 or later, follow the configuration steps provided in the Configure SmartConnector as a Transformation Hub Producer section in the SmartConnector documentation.
Follow the steps in this section to configure a SmartConnector with a Transformation Hub destination with the encrypted security mode that you require. These procedures are provided with the following assumptions:
-
You use the default password. To set a non-default password, see Password Management in the ArcSight SmartConnectors 24.2 documentation.
-
You are using a command window to specify Windows commands. Do not use Windows PowerShell for these commands.
<th hostname>refers to the FQDN hostname used to access the worker nodes in