Configuring the Username Variable

This section describes configuring the isAdminsSourceNamelowerIso variable. This variable identifies the source username that is an admin user or a non-admin user.

The following reports use this variable:

An additional variable, isAdministratorISO, performs the same function as isAdminsSourceNamelowerIso. However, instead of using the source username, this variable uses the destination usernames. You need to configure both variables according to the users you want to view in the reports.

Administrative Actions All Events Report and User Actions Summary Report

The reports Administrative Actions All Events and User Actions Summary might have an aggregation and grouping enabled. Therefore, you need to change the view first.

To configure the variable:

  1. Select Reports > Content.
  2. Click the Change View icon.
  3. Select Meta Detail View.
  4. Scroll to the right until you locate the isAdminsSourceNamelowerIso variable.

  5. Click the formula icon, which is identified with an.

    The Formula Editor pop-up displays.

  6. Modify the formula as needed.
  7. Click OK to save the data worksheet.
  8. To change the view back to the original display, click the Change View icon, and select Meta Data View.

 

User Logins and Logouts Report

To configure the variable:

  1. Select Reports > Content.
  2. Scroll to the right until you locate the isAdminsSourceNamelowerIso variable.

  3. Click the formula icon, which is identified with an.

    The Formula Editor pop-up displays.

  4. Modify the formula as needed.
  5. Click OK to save the data worksheet.