Some terminals support a line drawing set. This is used by the Terminal Manager when boxes are drawn around windows. The Terminal Manager turns on the graphics mode by sending the GO code, then sends normal characters that correspond to the lines, and then sets the terminal back to normal mode with GF.
The GM function lists the normal characters that draw the line segments. This is either a six- or eleven- or thirteen-character string. The characters listed in the GM function correspond, in order, with the following line segments:
This is the six-character set. If the terminal has the following line segments, the characters that correspond to them should be included (in order) to make the eleven-character set:
four three-way intersections:
This is the eleven-character set. If the terminal has the following block characters, the characters that correspond to them should be included (in order) to make the thirteen-character set:
On a few terminals, the graphics-on and graphics-off sequences are treated as character attributes. In particular, turning off graphics also sets the terminal to its default video attributes. If this is the case, then the code GA (graphics are attributes) should be included in the terminal description. A few terminals also cannot move the cursor while in graphics mode. If this is the case, the code GX (graphics movement glitch) should be included.
Some terminals do not need to send a graphics-on or a graphics-off sequence. For these terminals, the line-drawing characters are available in the default character set. If this applies to your terminal, then just give the GM setting without the GO or GF settings.