Starting the Controller

You can start the Fortify ScanCentral SASTController manually or set it to start automatically, as a service. For information about how to start the Controller automatically, see Installing the Controller as a Service.

To start the Controller manually:

To upload your scan results to Fortify Software Security Center, make sure that the Fortify Software Security Center instance is running.
On the machine that hosts the Controller, go to tomcat/bin/.
At the command prompt, run one of the following commands:
- On a Windows system, run startup.bat.
- On a Linux system, run ./startup.sh.
If Tomcat is running as a service, rather than running the startup command, you can just start the service.