To automatically retrieve information from a Lithium community, create a new fetch task by following these steps. The connector runs each fetch task automatically, based on the schedule that is configured in the configuration file.
To create a new Fetch Task
In the [FetchTasks]
section of the configuration file, specify the number of fetch tasks using the Number
parameter. If you are configuring the first fetch task, type Number=1
. If one or more fetch tasks have already been configured, increase the value of the Number
parameter by one (1). Below the Number
parameter, specify the names of the fetch tasks, starting from zero (0). For example:
[FetchTasks] Number=1 0=MyTask
Below the [FetchTasks]
section, create a new TaskName section. The name of the section must match the name of the new fetch task. For example:
[FetchTasks] Number=1 0=MyTask [MyTask]
In the new section, set the following configuration parameters:
CommunityUrl
|
The URL of the Lithium community to connect to. |
For example:
[MyTask] CommunityUrl=http://my-lithium.com
(Optional) If the connector must log on to retrieve information, specify a user name and password in the configuration file. For example, to configure basic authentication, set the following parameters:
BasicUsername
|
The user name to use to access resources protected by basic authentication. |
BasicPassword
|
The password to use to access resources protected by basic authentication. Micro Focus recommends encrypting the value of this parameter before entering it into the configuration file. For information about how to encrypt passwords, see Encrypt Passwords. |
For more information about the parameters that you can use to configure the connector, refer to the Lithium Connector Reference.
(Optional) If you installed the connector on a machine that is behind a proxy server, set the following configuration parameters:
ProxyHost
|
The host name or IP address of the proxy server to use to access the Lithium community. |
ProxyPort
|
The port of the proxy server to use to access the Lithium community. |
Save and close the configuration file.
You can now start the connector.
|