To automatically retrieve content from AEM, create a new fetch task by following these steps. The connector runs each fetch task automatically, based on the schedule that is defined in the configuration file.
To create a new Fetch Task
In the [FetchTasks]
section of the configuration file, specify the number of fetch tasks using the Number
parameter. If you are configuring the first fetch task, type Number=1
. If one or more fetch tasks have already been configured, increase the value of the Number
parameter by one (1). Below the Number
parameter, specify the names of the fetch tasks, starting from zero (0). For example:
[FetchTasks] Number=1 0=MyTask
Below the [FetchTasks]
section, create a new TaskName section. The name of the section must match the name of the new fetch task. For example:
[FetchTasks] Number=1 0=MyTask [MyTask]
In the new section, set the following parameters. These parameters are required to connect to the AEM repository.
UseSecureConnection
|
A Boolean value that specifies whether to communicate with AEM over HTTPS. |
AEMHost
|
The host name or IP address of the AEM server. |
AEMPort
|
The port number for the AEM server. |
BasicUsername
|
The user name to use to access AEM. |
BasicPassword
|
The password to use to access AEM. |
ProxyHost
|
(Optional) The host name or IP address of the proxy server to use to access AEM. |
ProxyPort
|
(Optional) The port of the proxy server to use to access AEM. |
|