Tabs Tab (Terminal Setup Dialog Box)

Getting there

Open a VT terminal session.

The steps depend on your user interface mode.

Ribbon or InfoConnect Browser

With a session open in InfoConnect, from the Quick Access Toolbar, click .

TouchUX

Tap the Gear icon and then select Document Settings.
Under Terminal Configuration, click Configure Terminal Settings

Tab Stops

Tab stops

Use the mouse, cursor keys, or Spacebar to move the scroll bar to the desired column and click; a T appears on the ruler. Repeat the procedure until all tabs are set. If you're in 132-column mode, use the scroll bars to move beyond the 81st column to set a tab stop.

To clear a single tab stop, click the tab position with the mouse (each click of the mouse toggles between setting a tab stop and clearing it).

Clear All

Click to clear all tabs set on the tab ruler.

The left margin is always an implicit tab stop and is not affected by Clear All.

Set Every

To set tab stops at equidistant positions, enter a number in the box and clickSet Every.

Ribbon or InfoConnect Browser	With a session open in InfoConnect, from the Quick Access Toolbar, click .
TouchUX	Tap the Gear icon and then select Document Settings.