From InfoConnect Manager
Select Paths in the left pane, then click Add.
Select SABRE2 and click OK.
Enter a Path ID and click Configure.
From the Database Editor
Under Connection type, select SABRE2.
Select an existing path (or, click + to add a new record).
Click Configure Path.
NOTE:To configure and use a SABRE2 path, you must first install and configure third party software (CCSAPI from Sabre).
Addressing
Select one of the following for the address.
Use fixed address (LNIATA) |
Enter the six-digit LNIATA address. This is comprised of two digits each for the line number, interchange address and terminal address. |
Allocate address from pool |
If you use an address pool, either select a preconfigured address pool from the list or click Configureto configure the address pool. |
SABRE CSAPI Route Name |
Specify the name of a route in the csapi.cfg file. |
ALC configuration (.cnf) file |
Specify the full path to the ALC configuration file. |