Skip to content

SABRE2 Path Configuration Dialog Box

How do I get to this dialog box?

From InfoConnect Manager

  1. Select Paths in the left pane, then click Add.

  2. Select SABRE2 and click OK.

  3. Enter a Path ID and click Configure.

From the Database Editor

  1. Under Connection type, select SABRE2.

  2. Select an existing path (or, click + to add a new record).

  3. Click Configure Path.

Note

To configure and use a SABRE2 path, you must first install and configure third party software (CCSAPI from Sabre).

Addressing

Select one of the following for the address.
Use fixed address (LNIATA) Enter the six-digit LNIATA address. This is comprised of two digits each for the line number, interchange address and terminal address.
Allocate address from pool If you use an address pool, either select a preconfigured address pool from the list or click Configure to configure the address pool.
SABRE CSAPI Route Name Specify the name of a route in the csapi.cfg file.
ALC configuration (.cnf) file Specify the full path to the ALC configuration file.