Skip to content

Page Setup for PTRSpooler

How do I get to this dialog box?

  1. Select Paths in the left pane, then click Add.

  2. Select PTRSpooler and click OK.

  3. In the Add Path dialog box, click Configure.

  4. If the Print Setup dialog box opens, make any required changes and click OK.

  5. In the PTR Print Spooler Configuration dialog box, click Page Setup.
Header The information that you want to appear in the header of the printed document.
Default value: &P Document Name: &F
If you do not want a header, delete the default content.
This text box can contain up to 132 characters. You can also use the following predefined variables:
&P is Page number.
&F is the document name (as specified in the Document Name text box on the PTR Print Spooler dialog box).
&D is the current date.
&T is the current time.
Footer The information that you want to appear in the footer of the printed document.
Default value: &D &T
If you do not want a footer, delete the default content.
This text box can contain up to 80 characters. You can enter any combination of text and the predefined variables described above.
Units The unit of measure to use. These units apply to the margin and tab settings.
Margins Margin settings for the Left, Right, Top, and Bottom margins.
Wrap Around Line: Select this check box so that when a line extends past the margins, the line will wrap to the next line. When the check box is cleared, the line excess is not printed.
Tabs The number of units per horizontal tab. The tab stops start at the left margin.