In InfoConnect Manager 32, click Configure and select Paths. Click Add. From the Path Template drop-down, select TELNET and click Configure.
Configuring TELNET Template Parameters
When you configure a template that uses the TELNET Service Library and an underlying TCP or WinSock EIL, you will be asked to supply the following information:
Host IP Address
Enter the IP address (TCP/IP internet address) or domain name of the Distributed Communications Processor (DCP), Host LAN Controller (HLC), A Series host, DEC host, UNIX host, or other host.
Terminal Type
Select the appropriate terminal type: NVT, VT100, VT220, ANSI or Other. If you choose Other you should supply a name that will be used to identify the terminal type to the host at the other end of the connection.
Remote Echo
If you select the Remote Echo option, characters typed at the keyboard will be echoed back from the remote computer instead of being displayed directly on the screen by your application. You should choose this option only if your application requires it, since it can add considerable overhead to your response time.
Binary
If you select the Binary option, your application will be able to transmit non-ASCII data without having it translated. Check your application's documentation to see if you need to set this option.
Customize Telnet
Click on this button if you wish to enter values for Telnet path fields instead of accepting the defaults provided.
Customize TCP
Click on this button if you wish to enter values for TCP path fields instead of accepting the defaults provided. Choose OK to complete the configuration. Choose Cancel to ignore your changes.