Starts a service execution process. You should use this command only
when you want to debug a service, using the /a option.
Syntax:
cassi [/res-name]
[/a]
Parameters:
| /res-name |
Name of the enterprise server for which to start a
service execution process. Defaults to ESDEMO |
| /a |
Debug any application that runs in this service
execution process |
Dependencies:
To use this command:
- You must have started the enterprise server named with the /r
flag first.
- You must be running under the same user ID as the enterprise
server named with the /r flag. If the
Directory Server was started as a system service, and the enterprise server was
started using the Administration interface, then the enterprise server is
probably running under the LOCAL_SYSTEM user ID, and this command will not
work. For more information see the section
Starting and Stopping the
Directory Server in
the chapter Introduction to Enterprise Server Administration in
your Enterprise Server Configuration and Administration
Guide.
Comments:
If the execution of this command takes the number of service
execution processes over the configured number, Enterprise Server will
terminate one of the service execution processes.