|
When you perform a file transfer, it defaults to the transfer type you select from this list. |
|
|
Select |
To do this |
|
|
Apply the items under (set from the tab) to be applied to the file contents, as well as any character set translation that you have opted to perform. |
|
|
Transfer the file contents unchanged. |
|
|
Have InfoConnect select the transfer type for you. |
|
When you perform an ASCII transfer with this option selected, InfoConnect translates characters based on the settings from the tab of the dialog box and the tab of the dialog box. |
|
|
Select to invoke settings automatically under on the tab. |
|
|
Select or type the sub-packet size for file transfers. This value tells Zmodem how many bytes of data to transfer at a time. In many cases, the Zmodem protocol will adjust this value during a transfer as necessary (the value shown in this dialog box does not change). |
|
|
If selected, when you initiate a send (from either a host system or bulletin board), InfoConnect immediately starts receiving a remote file with the same name as soon as it detects a Zmodem header. It is not necessary for the protocol to be set to in the dialog box for this to happen.NOTE:With automatic downloading, you are not prompted for a filename or a transfer method. |
|
|
Select to have a partially received file deleted automatically if you cancel the transfer in the middle of receiving a file. (If a download stop, but you did not cancel it, the received file is always kept. |
These startup commands are initiated from the host, which is why the term receive is used to describe the action of sending files to the host.
NOTE:These settings are necessary only when transferring files to and from a host system; they are not required for transferring files to and from a bulletin board.
|
When you send a file, this command is transmitted to the host. Type the name of the program that starts Zmodem receives on the host. If you do not indicate a receive startup sequence, you must manually start the Zmodem receive program on the host before you can send the local file. |
|
When you receive a file, this command, along with the name of the file to be received, is transmitted to the host. Type the name of the program that starts Zmodem sends on the host. If you do not indicate a send startup sequence, you must manually start the Zmodem send program on the host before you can receive the host file. For OpenVMS hosts, this sequence must be defined as a foreign command. |