The Fileshare Server uses the Enhanced Accept/Display syntax (Adis module) for its screen displays and keyboard handling. Consequently, the Fileshare Server uses much more processor time if you start it as a background UNIX process. To avoid this overhead, you should configure the Fileshare Server using the -b option. This disables all Fileshare displays and keyboard reading.
Since Fileshare does not read the keyboard in background mode, you cannot close it down in the normal manner using the Esc key sequence.
Do not kill the Fileshare process because this results in the corruption of any data files which are open.
Because you can only shut down the Fileshare Server remotely, the Fileshare Server must have been configured to use a password file. See Password File Maintenance in the Security section for details.
There are three methods you can use to shut down the Fileshare Server remotely:
The Fileshare Server does not start in background mode unless you start it with a password file.
In background mode, any messages the Fileshare Server would normally display on the screen are written to the file fsscreen.lst in the Fileshare Server's current directory.
An example configuration file follows.
-s server-1 -pf password.fil -cm ccitcp
This configuration file specifies:
On UNIX, you can now start the Fileshare Server in background mode by entering:
fs -b > server-1.log 2>&1 &
On some UNIX systems, output can be sent to the terminal after it has been disconnected. When this happens the entire session terminates. Consequently, you need to redirect the output from the command.