Configuring Advanced Settings

Configure settings on the Advanced tab to improve verification performance and enable support for IMS Analysis, Executive Report, and WebGen. The settings are described in the table below.
Setting Description
Launch standalone Queue Processor Check this box to launch the Queue Processor. Using the Queue Processor generally improves verification performance.
Number of extra Queue Processors If Launch standalone Queue Processor is selected, click the arrow buttons to specify the number of additional Queue Processors you want to launch.
Generate PCF Generate the project control file (PCF) before updating the sources and/or after verification.
Drop indices Controls the dropping of indices before verifying.

Auto - drops the indices only if WS objects count is above 256

Yes - always drop indices

No - do not drop indices

Clean Queue before processing All items in the queue will be deleted when the Queue Processor is launched.
Wait for Queue to become empty before processing If there are items to be processed in the Queue when the Queue Process is launched, the batch refresh process will wait until the Queue is cleared.
Wait until Queue is processed Check this box to force BRP to wait until the Queue Processor(s) queue is empty.
Timeout in minutes      If Wait until Queue is processed is selected, click the arrow buttons to specify the time in minutes BRP should wait for the count on the Processor(s) queue to change. If the count does not change within the specified time, BRP resumes. Sixty minutes is recommended.
Run IMS Analysis Check this box to enable IMS Analysis.
Restore indices Restore indices after verification
Run WebGen Check this box to enable WebGen.
Run Executive Report Check this box to enable Executive Report.
Report Folder Specifies the folder to store the Executive Report in. Use the Browse button to locate the folder.
Debug Check this box to enable debug mode, in which additional messages are written to the BRP log.